Dynamic Kill Modeling
Active well kill modeling and real-time kill analysis has been proven to be a valuable risk management tool for operators in support of pre-planned and ongoing drilling operations. Modeling software has the ability to simulate kick behavior of a well, allowing for the determination of kill methods with the ability to change mud weights, pump rates, and equivalent circulating density as required. With additional well data incorporated into the modeling program, further information can be developed to assist operators with DS design, FIT/ LOT/EMW, casing shoe placement, and the identification of potential lost circulation possibilities.
Dynamic kill modeling is a valuable tool that has been successfully used to control and kill blowouts. The technique pumps weighted drilling fluids calculated by the model down the wellbore at higher pump rates. The specific fluid dynamics created by this pumping method greatly enhances the friction within the wellbore, thereby controlling the flow successfully killing the well.
Cudd Well Control uses Drillbench Dynamic Well Control and Blowout Control program to conduct well kill modeling and real time kill analysis for our clients.
Simulations Analysis
- Underbalanced Operations
- Blowout Control
- Well Control
- Pressure Control
Information for Dynamic Kill
- Kill Mud Density
- Kill Mud Volume
- Dynamic Kill Pump Rate
- Dynamic Kill Pump Pressure
Benefits
- Various Scenarios
- Multi-phase Flow Simulations
- Graphics
- Skilled Users
- Real Time Support
Blowout Response Where You Need It
Our strategically located well control response centers cover key locations in the U.S. and beyond to bring high-quality engineering solutions for industry-leading service. Click here for locations
Emergency Response Plan Before You Need It
Whether it's pressure control, blowout prevention response or planning for an emergency you hope never comes, consult our expert prevention services for quality engineering, planning and training.